Specjalized Tools For Motorcycles
-
A-MK830
ALTERNATOR REMOVAL TOOL Fits most big twin with Bosch alternator mounted at the front of the crankshaft. Use to remove retaining bolt, screw in tool until snug, rap head with mallet, rotor should pop off from taper.
-
A-MK819
SHAFT HOLDING TOOL SET There are magnets on the tool to prevent falling while service. Size : 14, 16, 18, 32, 35, 10, 12, 12.5, 14, 20, 24, 29 mm and 1/2
-
A-MK812
CARBURETOR FLOAT HEIGHT TOOL Screwed into the bottom of the float bowl on through the drain plug hole. with the petrol tap switch on and the pipe next to the carb the actual level of the fuel can be seen in the float. It fits Mikuni VM Carburetor 22/24/26/28mm.
-
A-MK793
BEARING DRIVER SET Set fits bearing with 8-30 mm I.D. and 32-47 mm O.D. Set provides one durable steel handle and 12 sizes of anodized aluminum adapters : 8mm, 10mm, 12mm, 15mm, 17mm, 20mm, 25mm, 30mm, 32mm, 35mm, 40mm and 47mm. Set can be used with a hammer or shop press.
-
A-MK735
BEARING DRIVER SET Set fits bearing with 8-30 mm I.D. and 32-47 mm O.D. Set provides one durable steel handle and 12 sizes of anodized aluminum adapters : 8mm, 10mm, 12mm, 15mm, 17mm, 20mm, 25mm, 30mm, 32mm, 35mm, 40mm and 47mm. Set can be used with a hammer or shop press.
-
A-MK730
QUAD-STAKE RIVET KIT This river kit will safely and properly peen soft-nose-type master link pin tip. Retain that factory quad-stake look.
-
A-MK727
22MM AIR FORK HEX TOOL Used to remove the lower sealing bolt from Showa SFF air fork. Material: 6061 aluminum with anodized finish.
-
A-MK725
DAMPER ROD LOCKING TOOL FOR HYDRAULIC FORKS Sets Include : Sizes : M10 x 1.5/M10 x 1.25/M8 x 1.25 M7 x 1.0/M6 x 1.0
-
A-MK724
FF TOP CAP SOCKET For all K-Tech Suspension front fork cartridges and fork assemblies.
-
A-MK697
AIR VALVE PULLER A must have item for tire changes and repairs, easy to pull air valve through hole on the rim.